UPS Sizing Tool Virtual Tour

Step 2 – REQUIREMENTS

It is now time to enter the details of your requirement!

(1) Enter a Project Name. This may be a customer name or a particular project or bid you are participating in. For example, ABC Inc. POS Project, Hi-Tech Mktg. Server Installation Project.  (2) Select the UPS Application you wish to have this solution for. You may select any of the following: Desktop Application, Tower Server and Rack Server.  (3) In the Power Load Requirement field, you may select Yes if you know the total power load of your IT equipment. Once you select YES, another field pops up. (4) You will then be required to select the range where the total VA rating of your equipment falls under. (5) From the next dropdown fields, select the backup time and Growth Factor Rate you need for your solution. This page will ask require you to select the equipment you have among the available models in the tool. Do the selection from top going down.

Be sure that the project name contains keywords which you may use in future transaction searches. You may key in dates, company names or any other codes you may have. It is also recommended that you keep a list of these project names for your reference in the future.  • If you know the total power load requirement of your equipment, most likely you will get an automated response from the tool. • If you do not know the total power load requirement, click on NEXT and you will go on to the next page.

 

(6) Select the Equipment Type from the dropdown field. After selecting the equipment type, choose among the Brand and subsequently, the Equipment model name. Allow the tool to load the next level of selection before proceeding. (7) Be sure to specify the Quantity of your equipment. (8) Click on Add to List and a table with all your selected equipment will show up.

• If you entered the wrong information, you may delete that particular equipment and enter a new one all over again. You may delete only one equipment at a time.

(9) When you’re done selecting equipment or you did not find your equipment in the list, it’s time to choose from between two options.
        • When you select (a) “Equipment List is Complete” and click on CONTINUE, a system generated response will show up.
        • When you select (b) “I have other equipment not found in the list” and click on CONTINUE, you will go on to the next page.

This page will require you to enter the other equipment that are not found in the previous page.

(10) Enter the Brand, the Model and the Quantity of EACH Equipment. Please be exact and accurate.

(11) Click on Add to List and a table with all your additional equipment will show up.

(12) When you’re done, click on CONTINUE and you will be notified that your request is undergoing back-end processing.

Click on the Results button below to proceed to the next step.